Drager Bayonet Pad-Retainer, pack of 12
This bayonet-pad retainer from Draeger Safety is for use with their range of half and full face masks with a bayonet filter connection. The retainer comes in a pack of 12 pieces (6 pairs) and weighs approximately 20 grams per piece.
The bayonet-retainer can be used in two different ways. It can be combined with both a gas filter and a P1 or P2 Pad to create a combination filter or it can be used with a pad retainer and a P1 or P2 pad to create a complete particle filter. The retainer will clip onto both the gas filter and pad retainer to enclose the particle filters in between. See the example below.
Gas filter (e.g A2) + Pad P1 or P2 + Pad retainer = combination filter (A2 P2/P1)
The pad base can be purchased by clicking here.
- Suitable for use with both the X-plore 3300 and the 3500 half masks
- Also suitable for the X-plore 5500 full face mask
Colour Code | Filter Type | Contaminants present |
AX 1) |
Gases and vapours of organic compounds with boiling point < 65 °C | |
A |
Gases and vapours of organic compounds with boiling point > 65 °C | |
B |
Inorganic gases and vapours, e.g. chlorine, hydrogen sulphide, hydrogen cyanide | |
E |
Sulphur dioxide, hydrogen chloride | |
K |
Ammonia and organic Ammonia derivates | |
CO 2) |
Carbon monoxide |
|
Hg 3) |
Mercury vapour |
|
NO 4) |
Nitrous Gases including nitrogen monoxide |
|
P |
Particles | |
Reactor5) |
Radioactive iodine including radioactive methyl iodide | |
1) May only be used as supplied from factory. Reuse and use against gas-compounds is absolutely impermissible 2) One time use only. Dispose after use. Special guidelines according to local regulations apply 3) Only use for a max of 50 hours according to EN 14387 4) One time use only. Dispose after use 5) Special guidelines according to local regulations apply |